No products
Prices are tax included
Manufacturers
Brushless ESC multirotor Tattu BLHeli_S DSHOT, 30A, 2S-5S, w/o BEC, 3.6g (4 pcs)
TA-ESC-30A-4PCS
New product
This product is temporarily out of stock
- Share :
TATTU ESC 30A 2-5S is designed for superior performance in FPV Racing.
Supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us), Multshot(5-25us), Dshot150, Dshot 300 and even Dshot600 and all are automatically detected by the ESC.
High quality N-FET, half-bridge drive and PCB specialized for cooling, already flashed with BLHeli_S firmware.
Pre-flashed with the settings below.
DShot is a new communication protocol between flight controller (FC) and ESC, substitute to Oneshot and Multishot. DShot stands for Digital Shot.
Advantages of DShot
Compared to Oneshot and Multishot, we are informed that DShot is better because:
- No More ESC Calibration Required (no oscillator drift)
- More Accurate ESC Signal, and more robust against electrical noise
- Higher Resolution of 2048 Steps, compared to others of 1000 steps
- Faster Than Oneshot
- Safer, every signal – ESC can detect and reject corrupted data
DShot is a digital protocol. PWM, Oneshot125, Oneshot42, and Multishot these are all analogue signals and therefore they have potential issues with value accuracy.
For more info about DShot you can click here.
Specifications
Firmware: BLHeli_S V16.6 A-H-20
Max continuous load: 30A
Burst Current: 40A / 10sec
Lipo Cells: 2 to 5 cells
MCU: SILABS EFM8BB2 48MHz
BEC: No
Weight: 3.6g (board) 6.5g (total with wires and connectors)
Dimensions
PCB size: 26mm L * 14.5mm W
ESC height: 6mm
Signal wire: 150mm
Power wire: 100mm
